Our Mission: "Efficiently support the thoughtful exchange of knowledge, values and experiences among RV enthusiasts"
    iRV2.com RV Forum  Hop To Forum Categories  THE CHASSIS CLUB  Hop To Forums  Workhorse Custom Chassis Motorhome Forum    The Koni's are on!!!
Page 1 2 

Moderators: DriVer, edgray
Go
New
Find
Notify
Tools
Reply
  
-star Rating Rate It!  Login/Join 
""Monaco Owners Forum Member""

Picture of 03HRVacationer
Posted
I got home from work today and the Koni's were on the front steps, Thanks John, it was getting ready to rain but I went for it anyway, the drivers side front was a bugger, the old spacers were frose to the bolt, between WD and a torch I got the bolt out of the old shock, one of the spacers I cut with a sawsall took about an hour and a half, funny thing the passanger side took 5 minutes, the bolt was nice and shiny like it was new crome, go figure. The rears were easy, I'll take her for a spin tomorrow.

Thanks for the advise.

Al






Linda, Al & Haley
2003 HR Vacationer, Workhorse W22, 8.1 Koni's all around, Winegard 3005 HD Dish, 42" HD Visio in the basement and 32" HD in the overhead.

Working for the Weekend, Still!!






 
Posts: 106 | Location: Dover NH | Registered: August 19, 2007Reply With QuoteEdit or Delete MessageReport This Post

Posted Hide Post
You are going to enjoy the ride,especially when you encounter the tar strips and bridge approaches.Interesting that you had grief with the L/F shock,my experience was the same except the upper nut almost fell off as there were only two threads for the nut to engage.The OEM shocks had been replaced under warranty and the last guy to work on it was at the WH Dealer.When installing the new bolt,there was a definite alignment issue with the upper and lower bolts(they were not parallel)and required a bit of finesse to install so as not to repeat the thread mangling.


04 Southwind 37C W22
DIY Rear Panhard Rod
DIY Flash to pass switch
DIY Transmission temp. gauge
DIY 4 Way flashers
Koni's all around
'93 Saturn behind.
 
Posts: 96 | Registered: May 15, 2005Reply With QuoteEdit or Delete MessageReport This Post

Posted Hide Post
Al,

Glad to hear that they made it their safe, you never know with "ooPS" Hammer

Report back after you give them a good test drive, I think you will happy with the purchase Thumbs Up


Jon Brazel - Service Advisor
Brazel's RV Performance Center & Park
 
Posts: 11 | Location: Centralia, WA | Registered: June 20, 2008Reply With QuoteEdit or Delete MessageReport This Post

Posted Hide Post
We had our Konis installed a week ago today and we are rather pleased with them. We've been running 95 PSI in our front tires of our 37'4" W-22 class A, but I wonder if the ride can further be enhansed by dropping the fronts down to 88 PSI. Does anyone have an opinion on that? Chuck/Bagman57.
 
Posts: 183 | Location: Wyandotte, Michigan | Registered: September 20, 2006Reply With QuoteEdit or Delete MessageReport This Post
"Administrator"
"Workhorse Ambassador"

Picture of DriVer
Posted Hide Post
quote:
Originally posted by Bagman57:
Does anyone have an opinion on that?
Chuck/Bagman57, I certainly do. Smile

If you know the actual weights of your front axle you can use the Michelin inflation chart. I would also add +5 psi to that in order to allow a slight margin before the minimum inflation is realized. I am currently running a Pressure Pro and viewing the tires pressures from the inside of the cabin is great!

I run my pressures according to the GAWRs and I can't complain about the ride. My Konis work very well in this regard.

Regarding experimenting with air pressures - go ahead - it's only air BUT do not go below the minimums. You can always air up your tires to the previous air pressures you were running after they cool down.

I have also been pleased with the performance of my Crossfires.

I would try running 90 PSI in the front and see if that makes any difference at all however the difference between 88 and 90 is not that great so go for it! I'm sure you'll be OK.

Here at the GNR one guy told me that according to the Michelin inflation chart on his WGO Model 35A he is running 74 psi in the rears. All I can say is ... How low can you go!


03 Winnebago 38GWorkhorse W22Adventurer
08 Saturn Vue XE I4 FWDBlue Ox AladdinSMI's™ Stay-In-Play DUO
Nor'Easters - FMCA F290540 - W133150 - Roxy the Doxie


"Have You Forgotten?" Welcome to iRV2
 
Posts: 16669 | Location: Conway, SC 29527 | Registered: January 29, 2000Reply With QuoteEdit or Delete MessageReport This Post
""Monaco Owners Forum Member""

Picture of 03HRVacationer
Posted Hide Post
I got the coach out for a test ride on the new shocks,, wow what a difference, it's unreal!! So I figured with the money I saved installing them my self I went out and got a 32" Visio HD LCD for the over head, I figure for what I took off in weight with the tube job out of the coach I should beable to drop my front tire pressure by 3 lbs, I think the sag just came out of the roof. I just listed it on ebay under boat anchors.

Love the Koni's.

Jon we got to get together about the UP upgrade.

Al






Linda, Al & Haley
2003 HR Vacationer, Workhorse W22, 8.1 Koni's all around, Winegard 3005 HD Dish, 42" HD Visio in the basement and 32" HD in the overhead.

Working for the Weekend, Still!!






 
Posts: 106 | Location: Dover NH | Registered: August 19, 2007Reply With QuoteEdit or Delete MessageReport This Post
"Newmar Owners Forum Member & iRV2 Contributor"

Picture of Max Hubrich
Posted Hide Post
Al,

I love the way you "figure". I do it exactly the same way, ie: I saved "X" dollars doing it myself so I certainly can buy that new "Do-Dad" with that saved money. Your a man I can understand.

Keep up the good work!!


Max H
2002 Newmar Mountain Aire, 37', W-22, 8.1 Vortac, Ultra Power "stuff".
2006 Malibu.
Wife-Cindy.
Wortless Lab- Jessie (but we love her).
 
Posts: 277 | Location: Pikeville, NC | Registered: March 15, 2007Reply With QuoteEdit or Delete MessageReport This Post

Picture of Streamerman
Posted Hide Post
If we could just get the DW to figure the same way! Laugh


Streamerman,
2004 38' Gulf Stream Atrium 8379, W-22, 22.5 wheels, Blue Ox Aventa, 2001 Lexus RX300, DIY Rear Tracbar, Co-Pilot GPS Software
 
Posts: 238 | Location: The Villages, Florida | Registered: November 04, 2005Reply With QuoteEdit or Delete MessageReport This Post

Posted Hide Post
I have the 2006 Itasca 35U/W-22. Checking the Koni website...they offer the "new" FSD shock and they go for about 165 dollars each.

Question 1: Are these "FSD" shocks adjustable as the original Konis? Recommendation on website is to install them adjusted as received..then adjust as desired for ride tune..weight change etc. Has anyone preinstall or postinstall adjusted these for a W-22 ..front or rear?

Question 2: With the oil flow control internal mechanics versus gas charge...does very cold wx affect your ride...stiffen up?
 
Posts: 443 | Location: Brandon, SD | Registered: May 01, 2006Reply With QuoteEdit or Delete MessageReport This Post
""Monaco Owners Forum Member""

Picture of 03HRVacationer
Posted Hide Post
Pub,
I installed as delivered, we went up to the Bangor area this past weekend, bunch of shore roads and railroad tracks, all I can say is my coach rides like it never has before. It's quiter, way less sway, the porpesing is gone completly, a set of railroad track with a rise would have been good for a 4 rocker, that's what I call it. As far as cold weather is concerned, I won't be able to answer that one for a while.






Linda, Al & Haley
2003 HR Vacationer, Workhorse W22, 8.1 Koni's all around, Winegard 3005 HD Dish, 42" HD Visio in the basement and 32" HD in the overhead.

Working for the Weekend, Still!!






 
Posts: 106 | Location: Dover NH | Registered: August 19, 2007Reply With QuoteEdit or Delete MessageReport This Post
 Previous Topic | Next Topic powered by eve community Page 1 2  
 

    iRV2.com RV Forum  Hop To Forum Categories  THE CHASSIS CLUB  Hop To Forums  Workhorse Custom Chassis Motorhome Forum    The Koni's are on!!!

© irv2.com 2008