Our Mission: "Efficiently support the thoughtful exchange of knowledge, values and experiences among RV enthusiasts"
 
RV Parts and Accessories by RVupgrades.com
    iRV2.com RV Forum  Hop To Forum Categories  THE OWNER'S CORNER  Hop To Forums  Tiffin Motorhomes Owners Forum    Jack pads - whats your choice?
Page 1 2 3 

Moderators: Joe-K
Go
New
Find
Notify
Tools
Reply
  
-star Rating Rate It!  Login/Join 
"Tiffin Coach Owner's Forum Member"

Picture of Rob&Sue
Posted
I have a set of 4 of the 14x14x1/2 orange plastic ones from CW which are basically worthless unless you're trying to protect a finished concrete pad from rust stains. Frown

I also made up some pressure treated 2x12x14 (front) and 2x12x18 (rear) lumber pads. They worked well until their last use when I was on a brand new sloping asphalt pad. The larger ones under the rear jacks partially sank into the asphalt and began to crack along the gain of the wood. They didn't fully crack so I'm considering gluing and screwing a 3/4 plywood skin to each side of the lumber. That will make each pad 3 1/4" thick.

Any thoughts as to the pads being too thick (I only carry the two sets) or different/better alternatives?


2007 Bus 40QSP - Spartan
2002 Honda Odyssey
Roadmaster Blackhawk AT
Roadmaster 9160
Pete & Ed
 
Posts: 45 | Location: Weston, Florida | Registered: March 22, 2008Reply With QuoteEdit or Delete MessageReport This Post
""Fleetwood Owners Forum Member"
"Solo RV'ers Forum Member""

Picture of Rick Long
Posted Hide Post
I have the large pads also... but I have the smaller ones that come either 4 or 10 to a pack, from CW.. I have two 10-packs for a total of 20... I can get level just about anywhere. They're much lighter than wood and stack perfectly, plus they have a carry case.


'99 Fleetwood Bounder 32H
Las Vegas NV
No Dog, No Cat, No Co-Pilot
 
Posts: 199 | Location: Las Vegas NV | Registered: December 06, 2007Reply With QuoteEdit or Delete MessageReport This Post
"Tiffin Coach Owner's Forum Member"

Picture of jhughd
Posted Hide Post
Rick, are the ones you use from CW come in an orange carrying case? If so, how do they hold up to your coach weight? I used those under my 5th wheel to level and they cracked and even broke in half under the wieght. The 5th only weighed 13.5K.

JD


2007 Phaeton 36QSH. MBE926, titanium pearl.
2001 Jeep Grand Cherokee
 
Posts: 49 | Location: Senatobia, MS USA | Registered: July 19, 2008Reply With QuoteEdit or Delete MessageReport This Post
"Winnebago Coach Forum Member"

Picture of stearn
Posted Hide Post
I made mine with 2x12 sandwiched in 1/4" plywood 2ea. I attached nylon rope to make easy removal. The other 2 are 14"x14" 3/8 plywood, also with rope. The different thickness has worked well when pads are sloped, or level.Your plan sounds close to what I did. I haven't had any problem with splitting or cracking.


06 Adventurer 38R
Malinu Maxx Toad
 
Posts: 54 | Registered: July 29, 2008Reply With QuoteEdit or Delete MessageReport This Post
"Tiffin Coach Owner's Forum Member"

Picture of Rob&Sue
Posted Hide Post
quote:
Originally posted by Rick Long:
I have the smaller ones that come either 4 or 10 to a pack, from CW


I've seen them and they are nice and lightweight. My concern with them is at only 12x12x1" they might be a little small to use on anything other than a hard or well compacted dry surface. They may make a good supplemental pad on top of a larger pad.


2007 Bus 40QSP - Spartan
2002 Honda Odyssey
Roadmaster Blackhawk AT
Roadmaster 9160
Pete & Ed
 
Posts: 45 | Location: Weston, Florida | Registered: March 22, 2008Reply With QuoteEdit or Delete MessageReport This Post
"Monaco Owners Forum Member"

Posted Hide Post
Check out DICA for a permanent solution to your pad problem. I too used wood and they also broke and were a repair item. DICA pads are usually used in commercial applications such as backhoes, cranes and large utility trucks and are strong enough to last. JMHO
 
Posts: 186 | Registered: April 02, 2004Reply With QuoteEdit or Delete MessageReport This Post
"Tiffin Coach Owner's Forum Member"

Picture of Rob&Sue
Posted Hide Post
I've looked at the DICA and Summit Products pads. They are very well made and nearly indestructible. However, they are expensive for a set of 4 (at least $200) and are usually only an 3/4-1" thick. I know they will make them to any measurement and thickness desired but then the cost and weight go way up.

They would work really well as the base with 12x12" plywood or the CW interlocking pads as supplementals.

This message has been edited. Last edited by: Rob&Sue,


2007 Bus 40QSP - Spartan
2002 Honda Odyssey
Roadmaster Blackhawk AT
Roadmaster 9160
Pete & Ed
 
Posts: 45 | Location: Weston, Florida | Registered: March 22, 2008Reply With QuoteEdit or Delete MessageReport This Post
"Newmar Owner's Forum Member"

Picture of GaryKD
Posted Hide Post
I use the plastic and treated lumber in combination with each other. Two 12"X18" treated lumber screwed together with a rope attached for easy removal. On top of this is a plastic pad purchased at CW. For me, this has worked 100% of the time. The treated lumber has been with me for more years than I can remember.


Gary
2005 KSDP 3910
Wheelbase 252"
Cummins ISC 330 HP,
950 FT LBS Torque
Tow With Tow Bar & Dolly (not at the same time)
Coach & Towed Combined Weight Is 34K lbs.
NKK 17178 Life Member
FMCA F368169
GS 000612638 Life Member
Passport America Life Member
KOA Gold Camper Member
The States Visited Map Is Our Second Time Around
 
Posts: 2349 | Location: Wellington, Florida | Registered: July 19, 2006Reply With QuoteEdit or Delete MessageReport This Post

Picture of blacktie.shooter
Posted Hide Post
Reading quite a bit of knowledgeable discussion about pads here, let me ask a question: Why? What is the purpose? Are you trying to keep your tires off of blacktop during storage? Or just for a broader base on hot asphalt? I have a set of CW pads with long handles, and only use them for parking on grass or other soft surface. What am I missing?


Ken & Carolee
'95 36' Pace Arrow/Ford 7.5L/full synthetic/Banks Pack
'99 Saturn SL2 5-spd
Roadmaster Sterling All-Terrain
Brake Buddy

Travel Safe . . . But Travel.
 
Posts: 99 | Location: Vancouver, USA (WA, that is) the first one! | Registered: February 02, 2008Reply With QuoteEdit or Delete MessageReport This Post
"Excel Owner's Forum Member, Full-Timers Excel Club
"

Picture of LindaH
Posted Hide Post
quote:
Originally posted by jhughd:
Rick, are the ones you use from CW come in an orange carrying case?

Are you talking about the yellow levelers (I don't know what color carrying case they come in)?

If so, they're just about worthless for anything. The orange Lynx levelers are much, much better.

We had the orange Lynx levelers with our first fifth wheel. After 5 years when we sold it, we made the mistake of leaving the Lynx with the new owners and bought a set of the yellow ones from CW. Big mistake, because by the end of the first year, almost all of them had broken. We're now back to using the orange Lynx levelers...so far, after using them for 4+ years, we haven't lost a one.

Now, I must say that we haven't used them for the jacks on a motorhome, which undoubtedly weighs more than our fifth wheel, so I don't know how they would stand up...but they'd do much better than the yellow ones.


Linda Hylton
2007 Excel Classic 30RKE
2007 Dodge Ram 3500 Big Horn Edition
On the road fulltiming...see where we are now:
http://map.datastormusers.com/user1.cfm?user=1167
 
Posts: 823 | Location: Sioux Falls, SD | Registered: November 03, 2002Reply With QuoteEdit or Delete MessageReport This Post
 Previous Topic | Next Topic powered by eve community Page 1 2 3  
 

    iRV2.com RV Forum  Hop To Forum Categories  THE OWNER'S CORNER  Hop To Forums  Tiffin Motorhomes Owners Forum    Jack pads - whats your choice?

© irv2.com 2008