Hello I need some advices. During my last trip I noticed that my living/dinette room slide was leaking. It leak from the top down between the wood frames. I noticed the wood on top wet and now the paper is pealing off the wood. In looking on top of the slide roof I noticed that the piece of metal on the left side does not go end to end (from outside to inside) leaving a hole of about .5" on the inside. I was thinking of removing all the wood frames to replace with better one and adding Eternabond Tape from one end to the other where the roof meet the face where the wood is. Anyone have this problem that could help me out before I start this project.

How do I add a picture so that you can see the frame?

Well today I decided to remove the wood frame from the living/dinette slide. Now you see the metal frame, you know that this frame can get loose every time you open the slide. When you open the slide the pressure causes it to separate from the top of the roof and this metal frame casing water to leak in. Going to put Eternabond tape on top of roof where it will meet with the metal frame. Then replace with new wood frame and hopefully this will do the job.

You are a hands down guy that is willing to do it yourself. This way you know it is done right..

Yes George I feel this way I know it done the way I want it and at the same time change the molding around the slide to something nice. The old molding was nice but basically is made of cardboard and you know what happen to cardboard when it get wet. I will secure the metal frame around the slide to the slide box nice and tight then add the eternaband tape on the roof of the slide where it meet with the metal frame. Then add the nice molding that I am still shopping for. I am checking at Lowes and Home Deport. We are not going anywhere for now so we have the time.

Just noticed this post.Mine did the same exact thing. I chaulked the area you describe where the metal corner tries to meet the edge.Leak gone,fake wood damaged ,but not too bad to look at.My kitchen slide leaked,turns out to be the water heater is mounted a little crooked and when it rains , water seeps in.

Sometimes the Mfg forgets to place some sealent across the top lip of the water heater when they install flush against side wall.
Water could wind up on rug in bathroom.
Good job My Life #1 area where your slide can leak on some MFG models.

Frankie, or any other Hurricane (2006) could you check your living room slide and let me know if you have a metal piece going cross corner of the slide, (the metal piece is about 4 inches) as you face the living room slide is the bottom left side (slide is open)the other side behind the driver does not have this piece.

Any chance you can take a pic and post or e-mail it to me?

Check your e-mail Frankie for the pic

I got your pic. No, we dont have that cross piece. That, honestly, looks like a factory booboo.They must have chipped a corner,and repaired it.